![]() Most non-ferrous exotic metals, including aluminum, cannot be welded using the flux-cored method. The pool simultaneously melts the flux core of the electrode to create a protective shield from the environment and a slag that protects the weld from contamination. Together, the melting electrode and metal form a molten pool. As the wire electrode melts, the metal begins to melt, too. When the wire reaches the metal joint, a short circuit occurs, which causes the electrode to heat up and begin to melt. As the electrode is fed through the wire feeder, it becomes electrically charged. To begin the welding process using the flux-cored method, the welder first squeezes the trigger, which begins feeding the electrode continuously to the joint. As a result, the finished weld gets covered with a slag which may have to be removed. One of the downsides of using FCAW is that the welding arc does make spatter. There is no need to carry a separate gas cylinder to the welding site, which makes FCAW more convenient. This internal shielding can even endure strong breezes. When using the FCAW process on thicker metals, a good, strong weld can be produced in a single pass.īecause the flux-cored wire produces its own shielding gas during the welding process, FCAW works much better outdoors than does the MIG method. In fact, FCAW is recommended only on materials that are no thinner than 20 gauge. Using the FCAW Methodįlux-Cored Arc Welding works better than MIG welding when working with thicker materials. This type of wire eliminates the need for an external gas supply, because it has internal shielding properties. In contrast to the MIG process, the flux-cored method uses a wire that contains an inner core made of materials that produce fluxing agents and shielding gases when burned by the heat of the welding arc. This is usually provided by a high-pressure gas cylinder.Īs with MIG, FCAW requires electricity, filler metal, and some way to shield the molten metal from the air. An external gas supply is required to create a shield for protecting the molten pool. The MIG welding process uses a continuous solid wire electrode, typically made of mild steel. What primarily distinguishes FCAW from MIG welding is the type of wire electrode that is used and the way the molten metal is protected from the atmosphere. ![]() Flux-Cored Arc Welding is a welding method that is somewhat unique compared to Metal Inert Gas welding. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |